DATAQ Instruments, Inc.

Home | Products | Support | ContactUs | SiteMap

Online Store | www.dataq.com

DI-71x Ethernet Static Network Installation Problems and Resolutions for Windows 2000 and XP

View pdf View the pdf

On this Page

Symptoms

Cause

Resolution

Verify that your WinDaq Resource CD is dated September 2005 or later

Verify that the IP address assigned to your DI-71x is not in use

Verify Firewall Settings

Create a Debug710.log file

Applies To

Symptoms

While installing WinDaq for your DI-71x Ethernet device to a static IP network you encounter the following:

Upon selecting "Add IP" from the "No Devices Found" dialog box there is no MAC address listed in the "Manage IP Addresses" window.

View the pdf for images

Cause

This could be the result of one or more of the following:

Outdated installation software

The IP address assigned to the device is already in use

Conflicting firewall settings

Resolution

To resolve these issues follow the steps below.

Verify that your WinDaq Resource CD is dated September 2005 or later

If your WinDaq Resource CD is dated earlier than September 2005 download the latest revision of WinDaq at: http://www.dataq.com/support/upgrades/record/index.php.

View the pdf for images

Run the WinDaq installation program. Did WinDaq install properly? If not proceed to the next step.

Verify that the IP address assigned to your DI-71x is not in use

Your DI-71x Ethernet device must be assigned a unique IP address. Consult with your network administrator to identify an available IP address.

Run the WinDaq installation program. Did WinDaq install properly? If not proceed to the next step.

Verify Windows firewall settings

You must be able to send and receive data over your local area network in order to install and run WinDaq for your DI-71x Ethernet device.

We require and use the following ports:

10001

30178

6237

68

67

These ports cannot be blocked for TCP or UDP. Check with your IT department to verify that network broadcasts are not blocked for these ports.

Also, make sure that your Windows firewall does not block the WinDaq Installation Manager.

  1. Double-click on "Security Center" in the Windows "Control Panel."
  2. Under "Manage security settings for:" select "Windows Firewall."

    View the pdf for images

  3. Select the "Exceptions" tab from the "Windows Firewall" window and make sure that "InstallManager" is checked.

    View the pdf for images

Run the WinDaq installation program. Did WinDaq install properly? If not proceed to the next step.

Create a Debug710.log file

The Debug710.log file will provide information pertinent to your installation issue. The support staff at DATAQ Instruments will review the Debug710.log file and reply via phone or email with a solution.

  1. Download the Debug710.exe application at http://www.dataq.com/Debug710.zip.
  2. Unzip the Debug710.exe file into the directory where WinDaq is installed.
  3. Run the Debug710.exe application. This will generate a file called Debug710.log in the same directory.
  4. Email the Debug710.log file along with a description of the problem to support@dataq.com.

Applies To

All DI-71x Ethernet devices being installed on a static IP network under Windows 2000 or XP.

© 2008 DATAQ Instruments, Inc. All rights reserved. Date last edited 8/14/2006. Contact the Webmaster

Back to Top